CRL Z-Series Round Type 2″ Radius Base Stainless Steel Clamp for 3/8″ Glass

• For 3/8″ (10 mm) Glass
• Use Monolithic Tempered Glass
• Use on Mezzanines, Partitions, Railings and Windbreaks
• Steel Pin Available for Additional Glass Support
• Custom Painted Finishes Available Upon Request

OurCRL Z-Series Round Type Radius Base Glass Clampsare designed to be used on glass thickness of 3/8″ (10 mm), and are available in either zinc or stainless steel. The clamps are the perfect solution for partitions, railings, windbreaks and countless other projects.

For securing the Z-Clamp to thin wall tubing (less than 1/8), use CRLsZB0LTSocket Head Cap Bolt andZRNUTRivet-Nut. For installation, drill a 17/32 (13.5 mm) hole, then install the Rivet-Nut using 34604 Heavy-Duty Thread Insert tool and 34618 5/16 Mandrel and Nosepiece.

NOTE:1/2″ (12 mm) notch is required if using the steel pin (included with the clamp) for additional glass support. Replacement gaskets are available by ordering CRL Cat. No. Z14RG.

SPECIFICATIONS:
Glass Thicknesses:Models for For 3/8″ (10 mm).
Base Design:Radius
For Use With:1-1/2″ or 2″ (38 or 50.8 mm) Diameter Round Tubing
Material:Choice of Zinc Constructed or Stainless Steel. Stainless Steel or Powder Painted Zinc Clamps are recommended for more durability in exterior applications.
Glass Fabrication:
For 1/4″ (6 mm), 5/16″ (8 mm), and 3/8″ (10 mm)
Thick Glass: 1/2″ (12 mm) notch is required if using provided steel pin for glass support. For 1/2″ (12 mm) Thick Glass: 9/16″ (14 mm) diameter hole required if using provided steel pin for glass support.
Includes:Rubber Gaskets and Steel Pin (for optional use) with Grommet
Replacement Hardware:CRL P612 for Replacement Screws

Product Warning:

For interior and exterior applications CRL recommends pinning each glass panel as required when the glass is not supported from the bottom edge to prevent glass panel slippage. Rubber gaskets and steel pins are provided with each clamp.