Cordura Sewn Wear Pads for Slings for 2″ Webbing | 24″ Long

Once a sling steps up from single-ply to double-ply, or gets rigged in a double-leg roundsling configuration, the wear points on it multiply, and this sewn wear pad is sized to cover both. This Cordura sewn wear pad wraps and stays sewn to both sides of the sling, so it slides along the length for easy positioning and quick inspection instead of staying fixed in one spot.

Key Features

• Cordura fabric construction, abrasion-resistant for long-term use on the same sling
• Sewn on both sides for a secure, non-slip fit
• Slides along the sling’s length for easy repositioning and quick visual inspection
• 1-ply and 2-ply sling width: 2″
• 3-ply and 4-ply sling width: 1″
• Single leg roundslings: type 3
• Double leg roundslings: types 1 & 2
• Wire rope diameter: 7/8 – 1-1/8″
• Chain size: 9/32 – 3/8″

Applications

• Slings that stay in service long enough that abrasion resistance actually pays off over repeated use
• Rigging setups needing a Cordura sewn wear pad that can be repositioned for inspection without removing it
• Jobs where the sling contact point needs real long-term protection, not just a one-time barrier

Sleeve Inspections

Inspect the sleeve regularly and before each use. If you notice any damage, excessive wear, or an unreadable warning tag, remove the sleeve from service immediately.

ASME Guidance

“Slings in contact with edges, corners, protrusions, or abrasive surfaces shall be protected with a material of sufficient strength, thickness, and construction to prevent damage.” – ASME B30.9 (2021) 9-5.10.4(d)